![]() On the Join Parcel dialog box, choose Joining points held fixed at map position under Use the following method when I click OK.Click Keep And Join on the Parcel Details dialog box.Ĭlose or dock the Parcel Details dialog box.Parcel joining is an interactive process where the parcel points of a floating parcel or group of parcels are matched with their corresponding points in the parcel fabric. New parcels need to be joined to the parcel fabric to be connected to the parcel fabric. A newly created parcel is not yet connected to the parcel fabric layer, even if existing fabric points were used as from- or to-points in the creation of the parcel. When new parcels are added to the parcel fabric, they need to be joined to the parcel fabric layer. Large miscloses indicate a possible blunder in the entered dimensions. The misclose of the parcel is displayed at the bottom of the Parcel Details dialog box. Make sure that the Lots and Units layer and the Lines sublayer (under the Parcel Fabric group layer) is visible.In the Table Of Contents window, make only the Tax Parcels layer and the Tax Lines Anno layer selectable.Open the TaxParcelEditingMap document located in the MapsandGeodatabase folder or drag the parcel fabric (enabled with the Local Government Information Model) in the ParcelEditing feature dataset into an empty map document.to the true point of beginning, thence along a private road N5☄7'00"W a distance of 250 ft., thence N87☀9'54"E a distance of 295 ft., thence S1☃8'34"W a distance of 250 ft., thence S87☀4'00"W a distance of 262.62 ft. 1 the following courses, N4☂1'50"W 365 ft. ![]() The workflow consists of the components shown in the diagram below:Ĭomponents of a parcel split using measurements Legal descriptionĪ legal description for a parcel split using measurements and a point of beginning may look like this:Ĭommencing at the northwest corner of lot 15, Echo Park No. Select Parcel Split: Metes-And-Bounds and click Begin workflow. To use the Parcel Split: Metes-And-Bounds automated workflow, open the Parcel Workflows dialog box by clicking Parcel Editor > Parcel Workflows. To use the automated workflows on the sample data, enable the parcel fabric in the ParcelEditing feature dataset with the Local Government Information Model and drag the parcel fabric into an empty map document. The workflow uses the sample dataset downloaded with the Tax Parcel Editing map on the ArcGIS Solutions website. This workflow describes the steps for splitting a parcel using metes-and-bounds. This topic applies to ArcGIS for Desktop Standard and ArcGIS for Desktop Advanced only. Locate point of beginning or commencement point.
0 Comments
Leave a Reply. |